如何使用電熱恒溫培養箱
更新時間:2014-12-04點擊次數:2637
一、電熱恒溫培養箱的正常使用條件:
⑴環境溫度:5~40℃
⑵相對濕度:≤85%
⑶除地磁場外,無其它強磁場干擾。
二、操作方法:
1電熱恒溫培養箱用220V交流電源,電源插座應采用三孔安全插座,必須妥善接地,切不可將按地線接到煤氣管上。
2打開電源開關至“ON”位置,把設定測量開關置于設定位置,調節調溫旋鈕至所需實驗溫度,然后打回測量位置,此時加熱燈亮,機器開始工作,先把溫度微調旋鈕逆時針打至zui“-”位置,待加熱接近設定溫度時,開始間歇性加熱,紅綠燈交替閃爍,恒定一段時間后,將保持某一溫度值,根據此溫度值與設定值之間差別,調節溫度微調電位器,一般差別越大,調節越大,微調電位器調節的大小是根據設定溫度高低,箱體水量,環境溫度確定,在環境溫度,設定溫度變化不大的情況下,下次實驗則不需再調節,即保持原位置,若對實驗溫度精度要求較好時,可調節電位器,以保證控制精度。
3采用壁體加熱溫度均勻,但*次升溫慣性較大,上沖2-5攝氏度,待15分鐘后方能穩定。